Welcome to the Warner Instruments Knowledge Base
Please look around
We've structured this KB to mirror our product website. However, if you can't find your answer, then please submit a question and we'll respond directly to you.
|
Search the Knowledgebase |
Browse by Category |
|
|
|
View Questions by Category |
Fast-Step Perfusion Systems (33)
Fast-step, Fast-step system
|
Gas Controllers (3)
O2, CO2, pH
|
Perfusion Accessories (20)
Syringes, valves, manifolds, timers, parts
|
Spill Detection Systems (3)
Overflow, Spill
|
Syringe & Peristaltic Pumps (8)
Pumps
|
Valve Control Systems (22)
8-Channel, 6-Channel, Timers
|
|
Perfusion
|
|
Valve control, Fast-Step, Pumps, Gas controllers, Spill detection
|
|
There were 7 questions found in this category:
Can the syringes warmers (e.g. the SW-60) still do the job when using constant flow syringes?
The SW syringe warmers will heat DN-Series syringes but not as quickly as with a regular syringe. Recall that the DN-Series syringes have two syringes, each holding solution. While these two solutions are connected it will take some time for heat to communicate into the inner syringe Many resea ...
Does the VT-8 Software run on Windows 7?
Yes, the VT-8 Software runs on Windows 7 and is backwards compatible with Vista and all the other 64 bit systems.
Is it possible to control a VC-6 pinch valve sytem with a VC-8 controller?
YES. The VC-6 cable connector (15 pin male "D" type connector) fits into the VC-8 controller (15 pin "D" type female connector) and the wiring is setup, so that the VC-8 controller allows proper control of Valves 1-6 of the VC-6 pinch valve system (according to Guy). In general. The VC-8 can co ...
Will the VT-8 Software run on Linux?
No, at this time the VT-8 Software only runs on Windows.
Will the VT-8 Software run on Mac OS X?
No, at this time the VT-8 Software only runs on Windows.
Are the mini-valves available in a 3-way configuration?
The mini-valves come standard as a basic 3-way valve, with both normally open and normally closed ports connected to a common inlet port. The basic configuration allows configuring for either an A/B selection or flow-to-waste option using a single valve. The use of supplied plugs (used to block ...
Can a data acquisition program control the VC-77SP's perfusion time and sequence of drug?
The VC-77SP is comprised of two pieces of equipment; the SF-77B Fast Step Perfusion System, and the VC-6M Six Channel Mini-valve System. The VC-6M can be controlled by your data acquisition system via the six digital TTL signal lines (one per channel) located on the controller front panel. The S ...
|
|